Jiří Lopaur - Brusírna Válců

They sharpened how I wanted and sometimes even pockani.

BUT I HAVE NOT BEEN HERE FOR SEVERAL YEARS!

They do an amazing job, experts and professionals.

Willingness and professionalism of the old school. I have nothing to complain about.

Reluctance, arrogant behavior, I waited a month to cut the cylinder, overpriced

As always a great deal, a job well done

I had a complete GO engine done on the zetor 25 after the second old man started spraying water from under his head. After the telephone communication, I was told that they put the wrong seals in the set, let me have another one. I parted it and found that the head gasket was anointed with silicone on both sides. There is more that was and is wrong, they said a lot of money for this work.

I wanted to have a done engine head properly and that's why I had it done because I don't have the machinery for it. I had the head leveled, the valve seats sharpened, the valves closed, the guides replaced, the new gasket. and set the valve clearances because there is no hydroshell but it is set by replacing the whole calibrated bowls ... abbreviation Komplet GO. That's the way it was arranged, and I left with it. They called me after a week that it was done. The first surprise, the price is 4000 CZK higher than agreed ... I say ok ... but the head will be great. I didn't solve it. I'll take my head and look ... it's not straight-no need. I'll take my head off. Since I already had suspicions, I started to check what and how they did. The first pass-valves are leaking - after filling with oil within 3 seconds, all flowed like the Danube. And to be completely angry, the valve clearances of 0.1-0.15 were bigger than they should be. So complaints. There I learned that the gauges are pushed at an angle of 45 degrees and not straight, and since the 0.15 mm thick scale is equal to it, it will crush the valve spring. I looked at them like crazy and didn't understand if they were kidding or serious. They meant it. After half an hour of arguing, I resigned. They promised to look at it again. In 14 days the phone is done. again another 60km. They said they fixed everything and everything is as it should be. So I took my head and fired. He checked again and found that the valves had done ... only 3 of them had flowed. So the result is terrible ... the head is uneven and, moreover, scratched, perhaps from 80 emery, as they cleaned it, the valve clearances were worse than when I drove the head there for repairs and the tightness of the valves was also miserable. No more niches for me. Dejected and poor quality work, arrogant behavior. The price is meaningless due to the retaliation and its quality. I absolutely do not recommend and if you have the opportunity to do it yourself or put it elsewhere. :-(